#Traktor z1 line input software#

You can change this behavior by editing the javascript file to set TraktorS3.SamplerModePressAndHold = true. Pressing the button again will stop sample playback.

If you edit the javascript file and set TraktorS3.SixteenSamplers = true, the samplers on the right-hand deck correspond to Samplers 9-16.īy default, pressing a number button will activate a sample. In Samplers mode, the buttons on the left side of the controller correspond to Samplers 1-8.īy default, the buttons on the right side of the controller also correspond to Samplers 1-8. If you hold SHIFT and press a button, it will clear that hotcue. In Hotcues mode, pressing the number button will set the hotcue if none exists, and activate it if one does.

The grid of 8 buttons have two possible trigger modes: Hotcues, and Samplers. You see clipping indicated, lower the gain of the playing decks or use SHIFT + Main Volume knob. Peak display is only generated from software. Note that this will still also adjust the hardware gain, soĪfter you release SHIFT you’ll need to adjust the knob again. You can hold SHIFT and turn the knob to adjust Mixxx”

#Traktor z1 line input software#

Output in hardware, so it does not affect the software main output gain knob The Main Volume knob on the S3 controls the volume of the S3’s main SHIFT + EXT: Switches input sensitivity for the input connectors from Mic to Line and back again. The microphone does not respond to EQ or effects. By default, this uses a high-/low-pass filter, but a different effect can be chosen in the Equalizer section of Mixxx” Preferences.ĮXT: The EXT button changes the fourth channel pregain (knob), pfl, and volume (slider) adjustments to operate with the Microphone input. The FILTER knob controls the Quick Effect superknob.

The GAIN and equalizer HIGH/ MID/ LOW knobs and the CUE (headphones) button behave as labelled.įX Enable buttons: See Effect section below.